setting up my dd wrt v24 as a client bridge

I did not have these problems at my school, and could use UDP there just fine. I have a WRT54GL running v23 SP2, and just purchased a Nokia E61, set up the VoIP SIP phone, and had these same problems until I changed the transport type from UDP to TCP. Then, click Apply Settings.Just bought my E65, and didn't register to my Asterisk PBX through my WRT54GL / DD-WRT v23 SP2.ĭoes anyone confirm that the latest v24 SP3 allows registering ?īut I have a very important (to me) question : is the Nokia firmware buggy, or the specified DD-WRT releases ? If so, could Nokia release a better software that would be completely SIP compliant, rather than making fun of NAT and STUN issues ? Set DHCP 4 to vlan4 with a Leasetime of 1440 (24 hours).Ĭlick Save. Once again, Set DHCP 3 to vlan3 with a Leasetime of 1440 (24 hours). Set DHCP 2 to vlan2 with a Leasetime of 1440 (24 hours). Set DHCP 1 to vlan1 with a Leasetime of 1440 (24 hours). Set DHCP 0 to vlan0 with a Leasetime of 1440 (24 hours).

This creates 4 sets of automatic assignments within the 4 new segments of your network to be handled by the router automatically in the future. So, whenever someone authenticates into this section, this VLAN will assign it a user address in your network. What this area does is allow you to create multiple automatic assignment addresses for IP addresses in a network. Below the Port Setup area you will see a section titled DHCPD.

Setting up my dd wrt v24 as a client bridge